L1® Users Forum    Musicians  Hop To Forum Categories  General Forums  Hop To Forums  Illustrations of Band Setups    Help with 2 L1 systems
Go
New
Find
Notify
Tools
Reply
  
-star Rating Rate It!  Login/Join 
Posted
Hi,

4 piece band using 2 L1 Model 1 systems (1 B1 per side). Mostly classic rock. Also have 1 Tonematch. Basically we are replacing a standard PA (2 front, 2 monitors) with the 2 L1's. Using a regular mixer in addition to the Tonematch. I'm a bit confused as to the best way to connect the Tonematch and a reqular mixer. I'd like to use TM for 3 vocals and 1 Acoustic Guitar and the req mixer for 2 mic'd guitar amps, bass, 1 keyboard, a Kick mic & overhead. Is there a way to share the TM between the 2 L1's, or does it have to be used in one system only? I also want to use the remote for master volume, not the TM.
I've tried the TM in Ch3 on one L1 and reg Mixer in Ch 1&2 on same L1, but the TM & Remote seem to be battling eachother. I've read that it's better to use a standard mixer L&R outputs, one side to each L1 and hard pan L or R for instruments or vocals to the closest L1. But I like the TM for the vocal presets. Should I just use the TM on one L1 as master and the mixer to the other with the remote as master? We're also messing with the bass into a Bass Pod, then into Ch3 or 4 on one L1, bypassing the mixer

Thanks for any suggestions
Brad
 
Posts: 9 | Registered: Thu September 15 2005Reply With QuoteEdit or Delete MessageAsk Bose for help
ST
Picture of ST
Posted Hide Post
Hi Brad,

Is this your Sketch?
It looks like it is - I'll be back to you with some ideas in a little while.


-- click image to make changes to the live version --

Legend:
L1® Model I/Classic
T1 ToneMatch® audio engine
Orange numbers are Systems and Inputs using those Systems.
Blue ringed numbers are Channel connections to/from the Classic and Model I Systems.
Blue filled numbers are Channel connections to/from the T1 ToneMatch™ audio engine.
Green numbers are for general notes about the Sketch and connections to non-Bose gear.

Quoting bchulse from The Sketcher
quote:
4 piece band, 2-L1, Model 1 (1 B1 each) 3 vocals & 1 Acoustic Guitar to Tonematch,
Tonematch out to Ch 3 on L1-R
2 mic'd Guitar Amps, Kick, Overhead & 1 keyboard to mixer and hard panned L to Ch 1 on L1-L,
& Panned R to Ch1 on L1-R. Bass to Bass POD direct to Ch 4 on L1-R. Would like to use remote
for master on both L1 & L2 and Tonematch volume for Ch 3 only on L1-R
 
Posts: 23965 | Location: Canada (Vancouver) | Registered: Sat June 12 2004Reply With QuoteEdit or Delete MessageAsk Bose for help
  Powered by Eve Community  
 

    L1® Users Forum    Musicians  Hop To Forum Categories  General Forums  Hop To Forums  Illustrations of Band Setups    Help with 2 L1 systems


Bose | Privacy Statement | Terms of Service
© Bose® Corporation 2003-2009